0 Comment(s)
Print
E-mail Xinhua, January 12, 2024
Photo taken on March 13, 2019 shows the Boeing logo at its headquarters in downtown Chicago, the United States.[Photo/Xinhua]
The U.S. Federal Aviation Administration (FAA) has formally notified Boeing in a letter that it is conducting an investigation into Boeing's quality control after an in-flight blowout on Alaska Airlines 1282 last Friday.
In a statement released Thursday, FAA said the investigation will "determine if Boeing failed to ensure completed products conformed to its approved design and were in a condition for safe operation in compliance with FAA regulations."
The investigation is the result of an incident on a Boeing Model 737-9 Max where it lost a "plug" type passenger door and additional discrepancies, the statement said. "Boeing's manufacturing practices need to comply with the high safety standards they're legally accountable to meet."
"This incident should have never happened and it cannot happen again," FAA stressed.
The mid-cabin door plugs on a Boeing 737 Max 9 operated by Alaska Airlines became dislodged from the aircraft following an abrupt depressurization shortly after departure on Friday. As a result, a piece of the fuselage was expelled at an altitude of 16,000 feet.
The plane, bound for Ontario, California, executed an emergency landing in Portland just 20 minutes after takeoff.
The FAA on Saturday temporarily grounded 171 737 Max 9 planes on an international level with door plugs pending inspections.
Two airlines that operate Boeing 737 Max 9 in the United States, Alaska Airlines and United Airlines, later found either loose hardware or bolts in the assembly of door plugs on their aircraft.
The FAA's investigation is separate from an investigation conducted by the National Transportation Safety Board specifically into the incident itself, local media reported.
Go to Forum >>0 Comment(s)